Table of Contents
Advertisement
7. Fit the inner side sections pos. 6 without the roller rings. This is done by
Fig. 1:
8.
9. Fit the outer sections pos. 10 with the pin pos. 11. Secure with the
hooking onto the middle of the roller section itself so that the frame can
be turned to get the pin pos. 7 in.
This requires two people. It is important to guide the side sections so that
hole in the bushing is aligned with the hole in the pin. Lubricate the pins
before they are fitted, it is a tight fit. Do not strike the pin directly. Put a
wooden block in between so as not to damage the pin.
Take care that the section does not swing round!
Secure the pin with the loose bushing and M12 bolt pos. 8
Run the rams (pos.5) out slightly (blue hoses) and connect the inner
sections with the pins pos. 9.
When both sections have been fitted, swing them out carefully with the
rams. The rams ensure that they do not swing back and tip over
backwards.
Remember washers and split pins.
washer and screw the bolt, to which Loctite 270 has been applied, firmly
into the end of the pin.
7
Hide quick links:
Advertisement
Table of Contents
