Maintenance & Cleaning; Camera Body, Cables & Accessories; Lenses - FLIR ThermaCAM BX320 User Manual

Table of Contents

Advertisement

12
Maintenance & cleaning
12.1
Camera body, cables & accessories
The camera body, cables and accessories may be cleaned by wiping with a soft cloth.
To remove stains, wipe with a soft cloth moistened with a mild detergent solution and
wrung dry, then wipe with a dry soft cloth.
➲ Do not use benzene, thinner, or any other chemical product on the camera, the
cables or the accessories, as this may cause deterioration.
12.2

Lenses

All lenses are coated with an anti-reflective coating and care must be taken when
cleaning them. Cotton wool soaked in 96 % ethyl alcohol (C
clean the lenses. The lenses should be wiped once with the solution, then the cotton
wool should be discarded.
If ethyl alcohol is unavailable, DEE (i.e. 'ether' = diethylether, C
for cleaning.
Sometimes drying marks may appear on the lenses. To prevent this, a cleaning solu-
tion of 50 % acetone (i.e. dimethylketone, (CH
(C
H
OH) may be used.
2
5
➲ Please note the following:
Excessive cleaning of the lenses may wear down the coating.
The chemical substances described in this section may be dangerous. Carefully
read all warning labels on containers before using the substances, as well as appli-
cable MSDS (Material Safety Data Sheets).
Publ. No. 1558440 Rev. a156 – ENGLISH (EN) – February 28, 2006
H
OH) may be used to
2
5
H
O) may be used
4
10
)
CO)) and 50 % ethyl alcohol
3
2
12
99

Advertisement

Table of Contents
loading

Table of Contents