Mounting And Beam Alignment - Omron Sti F3SJ-B P25-01TS Series Quick Installation Manual

Function Selection

6-5. Mounting and Beam Alignment

Mounting brackets are not included in the product. You must purchase them separately.
Step1
1. Loosen the intermediate mounting bracket bolts.
Check
position
Step2
Mount
Step3
Align
beams
Hexagon socket head
cap screw (M3 x 12)
Loosen
Hexagon socket head
cap screw (M3 x 18)
Intermediate
Bracket (2)
2. Lightly tighten the intermediate mounting bracket to the case.
<Backside mounting>
Intermediate Bracket (1)
Tighten lightly
For position and number of intermediate mounting brackets, refer to 6-4 of this document.
7
Wiring
<Backside mounting>
Loosen
Loosen
Hexagon socket head
cap screw (M3 x 18)
<Side mounting>
Detach the intermediate
mounting bracket (2) from (3).
Intermediate Bracket (1)
Intermediate Bracket (2)
Intermediate Bracket (3)
Attach the intermediate
mounting bracket (2) to (3).
Intermediate Bracket (1)
Loosen
Intermediate Bracket (3)
Optical surface
Intermediate
Bracket (2)
Intermediate
Bracket (3)
Sensor is secured by
Intermediate Brackets.
Mounting/Beam Alignment
Hexagon socket head
cap screw (M3 x 12)
Intermediate Bracket (1)
Intermediate Bracket (2)
Intermediate Bracket (3)
Intermediate
Bracket (2)
<Side mounting>
Optical surface Intermediate Bracket (1)
Sensor is secured by
Intermediate Bracket (2)
Intermediate Brackets.
Pre-Operation Checklist /
Maintenance Checklists
Turn the intermediate mounting bracket (2) so that
the intermediate bracket (1) should be the bottom.
Intermediate Bracket (1)
Intermediate Bracket (3)
Tighten lightly
Intermediate
Bracket (3)
F3SJ-B-01TS
Quick Installation Manual