2. System Components
Beam
Indicator
Emitter
Connection
cable (Gray)
Extension cable
3. Light Curtain Setup Flow
Setup
Function Selection
Wiring
Mounting/Beam Alignment
Pre-Operation Checklists/Maintenance Checklists
Done
4. Function Selection Flow Chart
Wiring depends on the function to be used. Shown below are the available functions.
- External Test Function
- External Device Monitoring Function
- Auxiliary Output Function
For details, refer to F3SJ-B-01TS series user's manual.
F3SJ-B-01TS
Quick Installation Manual
Beam center-line mark
1. Top-beam-state indicator (Blue)
Receiver
2. Stable-state indicator (Green)
3. ON/OFF-state indicator (Green/Red)
4. Lockout indicator (Red)
Connection cable
5. Power indicator (Green)
(Black)
6. Test indicator (Green)
10. Bottom-beam-state indicator (Blue)
. . . .page 2
. . . .page 3
. . . .page 4
. . . .page 10
Receiver
Emitter
1. Top-beam-state indicator (Blue)
2. Stable-state indicator (Green)
3. ON/OFF-state indicator (Green/Red)
4. Lockout indicator (Red)
5. Communication indicator (Green)
6. Configuration indicator (Green)
7. Internal error indicator (Red)
8.
Not used
9.
External device monitoring indicator (Green)
10. Bottom-beam-state indicator (Blue)
2