Omron Sti F3SJ-B P25-01TS Series Quick Installation Manual page 10

Function Selection
5. Align beams based on the indicators.
Align the unit to the center
Step1
of the angle where stable
indicator (STB) turns ON
Check
position
Step2
Mount
Step3
Align
beams
The angle adjustment range of intermediate mounting bracket (F39-LJB2) is +/-30 degrees.
6. Fully tighten the hexagon socket screws (M3 x 8/M3 x 18) of top/bottom brackets and intermediate brackets that were lightly tightened.
<Backside mounting>
Tighten
securely
<Backside mounting>
Tighten
securely
Please do not tighten each screw one by one. Fully tighten all of them in a balanced manner at all places.
Tightening with torque exceeding the recommended value too much may lead to a failure.
9
Wiring
Align the unit to the center
of the angle where stable
indicator (STB) turns ON
Emitter
EMITTER
<Side mounting>
Tighten
securely
<Side mounting>
Hexagon socket
head cap screw
(M3 x 18)
(Recommended tightening torque: 0.54Nm)
Mounting/Beam Alignment
Receiver
TOP indicator
On when top end beam is received
(Blue)
On when light intensity is 170% or higher
STB indicator of receiving light output ON threshold
(Green)
On when bottom end beam is received
BTM indicator
(Blue)
RECEIVER
Enlarged view
Tighten
securely
Hexagon socket head cap screw (M3 x 8)
(Recommended tightening torque: 0.54Nm)
Enlarged view
Tighten
securely
Pre-Operation Checklist /
Maintenance Checklists
F3SJ-B-01TS
Quick Installation Manual