[Ftp Settings] - [Ftp Server Settings]; [Snmp Settings] - Olivetti d-COLOR P3100 Manual

1.5 Available operations in Administrator mode
Item
[User Name]
[Password]
[Realm]

[FTP Settings] - [FTP Server Settings]

To display: Administrator mode - [Network] - [FTP Settings] - [FTP Server Settings]
To use application software with which the FTP server of this machine is used to communicate, configure the
FTP server.
Item
[FTP Server]
[Port Number]
[Command Prohibit]
[PORT Command En-
hanced Security]

[SNMP Settings]

To display: Administrator mode - [Network] - [SNMP Settings] - [SNMP Settings]
Configure the settings for obtaining the machine information and monitoring the machine using SNMP (Sim-
ple Network Management Protocol).
Item
[SNMP Settings]
[SNMP]
[SNMP v1/v2c (IP)]
[SNMP v3 (IP)]
[UDP Port]
[SNMP v1/v2c Settings]
d-COLOR P3100
Description
Enter the user name (using ASCII characters of up to 20 bytes, excluding a co-
lon (:)).
This entry is required if you have selected [Basic] or [Digest] in [IPP Authenti-
cation].
Enter the password (using ASCII characters of up to 20 bytes).
To enter (change) the password, select the [Change Password] check box,
then enter a new password.
This entry is required if you have selected [Basic] or [Digest] in [IPP Authenti-
cation].
Enter the domain (realm) (using ASCII characters of up to 127 bytes).
This entry is required if you have selected [Digest] in [IPP Authentication].
Description
Select whether or not to use the FTP server function of this machine.
[Enable] is specified by default.
If necessary, change the FTP server port number.
[21] is specified by default.
Select a command to deny a receiving job from an FTP client when using the
FTP server of this machine.
Set this option to return an error when a PORT/EPRT command or PASV/EPSV
command is sent from an FTP client to this machine.
[Allow] is specified by default.
Select whether or not to enable this machine to run security measures against
FTP bounce attacks. This option is not available if [Command Prohibit] is set
to [PORT/EPRT].
When a PORT/EPRT command is sent from an FTP client, the data connection
is established only if both of the following conditions are satisfied.
• A port number less than 1024 is not specified.
• The IP address specified by the command is same as that specified when
a control connection is established.
[Enable] is specified by default.
Description
Configure the SNMP settings.
Select whether or not to use SNMP.
[Enable] is specified by default.
Select whether or not to use SNMP v1 or SNMP v2.
[Enable] is specified by default.
Select whether or not to use SNMP v3.
[Enable] is specified by default.
If necessary, change the UDP port number.
[161] is specified by default.
Configure the SNMP v1/v2c settings.
1
1-45