Compool CP3000 Installation & Operating Instructions Manual page 32

Compool Cp3000
ONCE ONLY PROGRAM
It is possible to program a "ONCE ONLY" program for any of the Equipment Keys on the Cp3000. When a ONCE
ONLY program is executed, it is erased automatically. This feature is useful to program the Spa in advance so it will
be ready for use within a 24 hour period. With this convenient feature, there is no need to "de-program" the spa after
use. The ONCE ONLY program simply erases itself.
Follow the standard programming procedure to Step 3, enter a START TIME only. Do not enter a RUN TIME (RUN
TIME should indicate 0:00). Press Program Key to return to the normal operating mode.
This feature may be combined with any program (i.e. if PROG 1 is already used, use PROG 2, PROG 3, or PROG 4).
REVIEWING THE PROGRAM(S)
To review the programmed operating cycle(s) of any piece of equipment:
1. Press the Program Key. The Display will indicate PROG (to show that Clock is in programming mode), plus a
row of blinking icons located immediately above the six Equipment Keys.
2. Press the appropriate Equipment Key (either #S, #P, #1, #2, #3 or #4). The icon above the Equipment Key will
stop blinking, the remaining icons will disappear, and the programmed START TIME (blinking) and RUN TIME
will be displayed.
3. The appearance of PROG 1 on the Display indicates that there is more than one operating cycle programmed for
this equipment. To review additional program(s), press Equipment Key again.
4. If you wish to review the operating cycle(s) of another piece of equipment, return to Step 2 (i.e. press the
appropriate Equipment Key).
5. When you have finished reviewing the various pieces of equipment, press the Program Key to return the Clock to
normal operating mode.
CANCELING PROGRAM(S)
It is possible to cancel one or more of the programmed operating cycles:
1. Press the Program Key. The Display will indicate PROG (to show that Clock is in programming mode), plus a
row of blinking icons located immediately above the six Equipment Keys.
2. Press the appropriate Equipment Key (either #S, #P, #1, #2, #3 or #4). The icon above the Equipment Key will
stop blinking, the remaining icons will disappear, and the programmed START TIME (blinking) and RUN TIME
will be displayed.
3. Press the Cancel Key. The Display will indicate a START TIME (blinking) of 0:00 and a RUN TIME of 0:00.
4. If you wish to cancel additional program(s), return to Step 2 (i.e. press the appropriate Equipment Key).
5. If you wish to cancel all of the programs, press and hold down the Cancel Key for 5 seconds. After 5 seconds, a
continuous alarm will sound (until you release the Cancel Key), indicating that all of the programming has been
erased.
29
Operating Instructions