Table of Contents
Advertisement
SAFETY WARNING: Never put your hand into area housing the fan while the fan is operating!
For optimal operation, clean range hood and any filter/grease tunnel/oil container regularly. Regular care will
help preserve the appearance of the range hood.
Cleaning Exterior surfaces:
•
Clean periodically with hot soapy water and clean cotton cloth. Do not use corrosive or abrasive detergent
(e.g. Comet Power Scruv
the stainless steel surface. For heavier oil use liquid degrease such as "Forumla 409
cleaner.
•
If the hood looks splotchy (stainless steel hood), use a stainless steel cleaner to clean the surface of the
hood. Avoid getting cleaning solution onto or into the control panel. Follow directions of the stainless steel
cleaner. CAUTION: Do not leave on too long as this may cause damage to the hood finish. Use a soft towel
to wipe off the cleaning solution, gently rub off any stubborn spots. Use a dry soft towel to dry the hood.
•
After cleaning, you may use non abrasive stainless steel polish such as 3M
the stainless luster and grain. Always scrub lightly, a with clean cotton cloth, and with the grain.
•
DO NOT allow deposits to accumulate or remain on the hood.
•
DO NOT use ordinary steel wool or steel brushes. Small bits of steel may adhere to the surface and cause
rusting.
•
DO NOT allow salt solutions, disinfectants, bleaches, or cleaning compounds to remain in contact with stain-
less steel for extended periods. Many of these compounds contain chemicals, which may be harmful. Rinse
with water after exposure and wipe dry with a clean cloth.
Cleaning Aluminum Grease Filter:
•
Filters should be cleaned after every 30 hours of use.
•
Remove and clean by hand. Spray "Formula 409
very dirty. Dry the filters and re-install before using the hood.
Replacing Filters:
•
Should filters wear out due to age and prolonged use, please contact Victory Range Hoods for replacement
filters.
Replacing the light bulb:
•
This range hood uses LED bulbs (please refer to the actual specification of the hood purchased):
USA/Canada: LED 5.5W Type GU10 120V
•
Make sure the range hood is unplugged or turn OFF breaker.
•
Make sure the lights are cool to touch, carefully put pressure on the bulb and turn counter-clockwise to
loosen and remove. Install a new light bulb and carefully press and turn clockwise to secure the bulb in place.
•
Turn ON breaker and range hood to test for operation.
MAINTENANCE
, EZ-Off
oven cleaner), or steel wool/scoring pads, which will scratch and damage
®
®
" or equivalent degreasing detergent and leave to soak if
®
" or "Fantastic
®
or ZEP
, to polish and buff out
®
®
SUNSET
" brand
®
|
17
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the SUNSET and is the answer not in the manual?