Victory Q1 Installation Manual And User's Manual

Victory Q1 Installation Manual And User's Manual

Professional built-in range hood

Advertisement

Quick Links

INSTALLATION GUIDE
AND USERS MANUAL
PROFESSIONAL BUILT-IN RANGE HOOD
Model Name:
Q1
Available Sizes: 27", 30", 36"
READ AND SAVE THESE INSTRUCTIONS
For residential use only.
Installer: Leave this guide with the homeowner.
Homeowner: Keep this guide for future reference.
Rev.20240710

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Q1 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Victory Q1

  • Page 1 INSTALLATION GUIDE AND USERS MANUAL PROFESSIONAL BUILT-IN RANGE HOOD Model Name: Available Sizes: 27”, 30”, 36” READ AND SAVE THESE INSTRUCTIONS For residential use only. Installer: Leave this guide with the homeowner. Homeowner: Keep this guide for future reference. Rev.20240710...
  • Page 2: Table Of Contents

    Venting Methods................18 Wiring Diagram................. 19 Range Hood Operations..............19 Troubleshooting................20 Use and Care Information..............21 Do’s and Don’ts of Duct Venting............. 21 Maintenance..................22 Bulb Replacement................23 Warranty..................... 24 Disclaimer..................25 Contact Us..................25 VICTORY range hoods | Q1...
  • Page 3: Important Safety Notice

    Use high settings on cooking range only when necessary. • Never leave surface units unattended at high settings. Boil overs cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings. VICTORY range hoods VICTORY range hoods...
  • Page 4 The manufacturer and/or distributor/reseller will not be held responsible for any damages to personal property or real estate or any bodily injuries whether caused directly or indirectly by the range hood. VICTORY range hoods | Q1...
  • Page 5: Electrical Requirements

    (at the range hood and at the junction box). Copies of the standards listed may be obtained from: * National Fire Protection Association Batterymarch Park Quincy, Massachusetts 02269 ** CSA International 8501 East Pleasant Valley Road Cleveland, Ohio 44131-5575 VICTORY range hoods...
  • Page 6: Venting Requirements

    If available, also refer to stove top manufacturer’s height clearance requirements and recommended hood mounting height above range. Minimum Duct Size: • Round - 6” minimum * Due to different ceiling height configurations, recommended height may not be applicable. VICTORY range hoods | Q1...
  • Page 7: Calculating Vent System Length

    Top Vent, 6 inch Round Venting Size Top Vent, 6 inch Round * Subject to change without notice, please contact your local reseller for details. * Subject to change without notice, please contact your local reseller for details. VICTORY range hoods VICTORY range hoods...
  • Page 8: Required Tools

    REQUIRED TOOLS REQUIRED TOOLS Marker or Pencil Putty Knife Tape Measure Phillips Screwdriver Level Power Drill Aluminum Tape Utility Knife Drywall Knife VICTORY range hoods | Q1...
  • Page 9: Parts Supplied

    PARTS SUPPLIED PARTS SUPPLIED Ø - 6” Transition Mesh Filters Range Hood (x2) (Model Q1-30 shown) NOTE: Where necessary, additional screws will be needed for installation and added support, but is not included. Please review contents before installation. VICTORY range hoods...
  • Page 10: Dimensions

    DIMENSIONS DIMENSIONS Hoodshown: Q1-30 Please refer to the next page for available models and their respective dimensions TOP VIEW Ø 6” Transition Power ¼ ¾ ” ” cable exit 8” 28” ½ ” FRONT VIEW SIDE VIEW 2” ½ ”...
  • Page 11 DIMENSIONS (continued) DIMENSIONS (Continued) 6”- Ø Transition ½ ” ½ ” 8” ½ ” ¼ ” ½ ” ½ ” ¾ ” VICTORY range hoods...
  • Page 12: Preparation

    NOTE: To avoid damage to your hood, prevent debris from entering the vent opening. 1. Disconnect power cord, remove the stainless steel baffle filter and grease tunnel. 2. Set aside the stainless steel baffle filters and grease tunnel until the range hood is properly installed. VICTORY range hoods | Q1...
  • Page 13: Rough-In

    120v Outlet can be located here Allow spacing for wood blocking to bottom panel 6” Transition Q1-30 Range Hood Side Cabinet Side Cabinet Min: 24” Cabinet surround should Max: 30” accommodate the bottom Optimal: 28” lip of the range hood...
  • Page 14: Installation

    Installation Holes Installation Holes Pre-drilled mounting holes are provided through each side of the hood. For a more secure installation, you may drill as many installation holes as needed to secure from the inside of hood. VICTORY range hoods | Q1...
  • Page 15 CAUTION: Make certain the range hood is secure before releasing! (5) Fasten remaining screws from the inner side of the range hood to the wood blocking. VICTORY range hoods | 15...
  • Page 16 Use 6” round steel pipe to connect the exhaust on the Ensure the cylinder duct passes through, leading to the hood to the ductwork above. Use aluminum foil tape to roof cut out for exhaust connecting duct. make all joints secure and air tight. VICTORY range hoods | Q1...
  • Page 17 While continuing to install the filter, ensure you depress the lever for the retractable tabs to clear way for flush insertion. Tab Inserts When filter sits flush within the opening, release the push lever to lock in place. VICTORY range hoods | 17...
  • Page 18: Venting Methods

    24” ½ Min height: 83 ” from bottom of duct to ground when range 36” height to stove is 30” typical * Due to different ceiling height configurations, recommended height may not be applicable. VICTORY range hoods | Q1...
  • Page 19: Wiring Diagram

    • Press the Light Switch to power off the lights • Press the Power Switch to turn off the power. • Press the Light Switch to power off the lights VICTORY range hoods | 19 VICTORY range hoods | 19...
  • Page 20: Troubleshooting

    The duct size must be 6”, or larger. Please make sure there are NO reducers or plenums in the duct work. • Refer to DO’S and DON’TS for DUCT VENTING page for illustrative examples. NOTE: For all other inquiries, please contact Victory Range Hoods. VICTORY range hoods | Q1...
  • Page 21: Use And Care Information

    CFM of the hood and increase the noise. c. DO NOT use plenum boxes. Boxes create turbulence and make the hood inefficient. Use a smooth elbow to guide the air outdoors. VICTORY range hoods | 21 VICTORY range hoods...
  • Page 22: Maintenance

    Dry filters and re-install before using hood. Replacing Filters: • Should filters wear out due to age and prolonged use, please contact Victory Range Hoods to order • Note: Also replace damaged filter that has punctured or broken mesh, bent or broken frame. replacement filters.
  • Page 23: Bulb Replacement

    5. Disconnect the power cable and discard the old light fixture 6. Reverse the steps to install a new LED light fixture 7. Turn ON breaker and range hood to test for operation. Light Housing Power Plug Hood Panel Flat-head Screwdriver Metal Clip VICTORY range hoods | Q1...
  • Page 24: Warranty

    Victory Range Hoods. The information in this document is subject to change without notice, please contact Victory Range Hoods for updated details. VICTORY range hoods...
  • Page 25: Disclaimer

    Toll Free: 1-800-394-4020 info@victoryrangehoods.com 583 Nicola Avenue, Port Coquitam, BC, Canada The information in this document is subject to change without notice, please contact Victory Range Hoods for updated details. Toll Free: 1-800-394-4020 info@victoryrangehoods.com VICTORY range hoods | Q1 The information in this document is subject to change without notice, please contact Victory Range Hoods for updated details.
  • Page 26 NOTES X2 |...
  • Page 27 NOTES X2 |...
  • Page 28 583 Nicola Avenue | Port Coquitlam | BC | V3B 0M3 Canada www.victoryrangehoods.com...

Table of Contents