Assembly Instructions; Step 1; Step 2; Step 3 - Uplift Desk Coffee Table Legs Manual

Table of Contents

Advertisement

!
CAUTIONS & WARNINGS
CAUTION: Read all instructions before assembly. Failure to assemble or operate properly may
!
result in damage or personal injury. Retain manual for future reference.
Copyright Notice: These instructions are a component of this accessory. These instructions are part of the scope of delivery, even if the item is resold. These instructions are also available on the UPLIFT Desk website: uplift-
©
desk.com. Excerpts or copies may not be forwarded to third parties or used in any other published form without the prior written consent of UPLIFT Desk. These instructions are subject to United States copyright law.
© UPLIFT Desk • 800-349-3839 • 512-614-3152 • info@upliftdesk.com • upliftdesk.com
90.014.01.1015v.A

ASSEMBLY INSTRUCTIONS

Step 1

Check the top of your table top for damage prior
to assembly. Place your table top upside down on a
debris-free carpeted area or a blanket. Make sure the
table top is upside down. Most UPLIFT Desktops are
predrilled for our desk frames - ignore these holes.

Step 2

There are no predrilled holes on UPLIFT Desks for at-
taching Coffee table legs, so choose locations you pre-
fer that do not interfere with existing predrilled holes
or grommet holes. Use a tape measure to ensure the
legs are evenly spaced from the ends of the table top
and from front to back. We recommend placing the
legs no more than a few inches in from each end to
ensure stability.
Once legs are in place, mark each mounting hole with
a pencil.
If you own a drill, you can make this a little easier by
drilling pilot holes where you've made your pencil
marks using a 1/8" diameter bit.
Note: DRILL NO DEEPER THAN 1/2". To ensure
this, we recommend wrapping a piece of tape
around your drill bit 1/2" from the tip. Stop drill-
ing just before the tape touches the desktop.

Step 3

Align the leg mounting holes with the pencil marks
or drilled holes and attach using the included Screws
and Washers.
Do not overtighten to avoid stripping.

Step 4

With the help of another person, carefully rotate the
assembled table upright and position it where you
would like it to be.
1/2''
4
AI-FRM404-1.1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Coffee Table Legs and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Frm404-blk

Table of Contents