Table of Contents
Advertisement
Card 4 gets lost
procedure from chapter 6.7.3 – Read
(inserting) programming card
programming card
position
card
1
card 1
2
card 2 (available)
3
card 3
4
card 4 (lost)
5
card 5
Pic.4 g): Deleting card 4 using the card 2, table after deleting card 4
It is necessary to
chapter 6.7.1 again. 1 – Read
15 s the programming mode is exited.
A new card is always inserted at the position after the last inserted card. In case of deleting
all cards using the procedure described in chapter 6.7.4, it is necessary to create a new
filing table.
6.8 ID expiration function
This function is implemented since the FW version 5.0.
It is possible to set an
occurs, the ID becomes invalid (expired). The expiration evaluation is performed on every
date change in the module's RTC and when the access rights are downloaded.
6.9 ID with Alarm flag function
This function is implemented since the FW version 5.0.
It is possible so set an
read, relevant alarm is raised (and the alarm output is switched for preset time).
– Delete it
using the card
again, then
again.
Register the change in your
add another card
(card 6). We proceed with the procedure from
+ (inserting) programming
position
card
1
card 1
2
card 2
3
card 3
4
card 4
5
card 5
6
card 6
Pic. 4 h): Table after inserting card 6
Expiration date
for every
Alarm – ID flag
for every
Page 16
2, which is available, and using the
+ (inserting) programming
card
2, and finally
table.
position
card
1
card 1
2
card 2
3
card 3
4
card 4
5
card 5
card, read
Register the change in your
ID
stored in the module. When the date
ID
stored in the module. When the ID is
card, then
5x +
+ (inserting)
cards
1-5, after
table.
Advertisement
Table of Contents
