Table of Contents
Advertisement
3.6.9. Info of instrument
Show basic information of the tester. (Serial number and firmware version)
3.6.10. Calibration
After maintenance, user can calibrate this instrument. In calibration mode, do 16 times test
on calibration anvil, then press
3.7. Completion of test zone and test part
After finishing measurements of one test zone, it will enter to next test zone automatically.
After all test zones have been measured, go to the completion interface of test part, and
the measurement for the current test part is completed. The completion interface of test
part contains Review test part result; Review test zone result, New part test, Re-testing the
current zone and Function menu.
On the interface for Review test zone result, measurements of this test zone are displayed
on the right, and paramter symbols of this test zone are displayed on the lower left.
On the interface for Review test part result, strenghts of each test zone are displayed on
the right, and the name and number of this test part are displayed on the lower left.
to finish calibration and exit this interface.
Review test zone result
Interface for Review test part result
Advertisement
Table of Contents
