Linhai ATV 500-D T3 EFI Service Manual page 223

CHAPTER 5 FINAL DRIVE
5. Apply some Loctite 510 silicone sealant on
the shaft neck of pipe joint N for the
installation.
Mount the pipe joint N on the suited hole of
the rear gear case G.
→Fig 5
Fig 4
Fig 5
LH500ATV-D T3 EFI SERVICE MANUAL 19.0
6. Mount the shaft neck of the bevel gear
comp.-driven E in the suited hole of the
needle bearing H.
Make the ring gear bearing housing C and
the rear gear case G together
→Fig 6
7. Tighten the six bolts M8×25 Q to a torque of
20~25N.m.
Tighten the two bolts M10×1.25×25 P to a
torque of 35~40N.m.
Tighten the HE× screw T
the nut M8 R to a torque of 20~25N.m .
→Fig 7
CHAPTER 5
Fig 6
the gasket| S and
，
Fig 7
FINAL DRIVE. 5- 19