Linhai ATV 500-D T3 EFI Service Manual page 222

CHAPTER 5 FINAL DRIVE
5.7 REAR GEAR CASE ASSEMBLY
Important: Before staring any operation
on the gearbox ，to ensure that the surface of
all parts is clean.
1. Mount the bearing A in the ring gear bearing
housing C.
Mount the O-ring B into the groove of the
ring gear bearing housing C.
→Fig 1
2. Mount the adjust shim D in the shaft neck of
the bevel gear comp.-driven E.
Mount the bevel gear comp.-driven E in the
bore of bearing A.
Mount the adjust shim F in the other neck of
the bevel gear comp.-driven E.
→Fig 2
Fig 1
Fig 2
LH500ATV-D T3 EFI SERVICE MANUAL 19.0
3. Mount the needle bearing H and the
needle bearing Ⅰ into the suited hole of
the rear gear case G.
→Fig 3
4. Apply some Loctite 510 silicone sealant on
the screw thread. Mount the bolt M8×12.5 J
that used for the auxiliary hole with the
washer K, tight securely (20~25N.m).
Apply some Loctite 510 silicone sealant on
the screw thread. Mount the drain plug
M14×1.25×12 L with the washer M, tight
securely (35~40N.m).
→Fig 4
CHAPTER 5
Fig 3
FINAL DRIVE. 5- 18