Linhai ATV 500-D T3 EFI Service Manual page 210

CHAPTER 5 FINAL DRIVE
5.5 FRONT DRIVE AXLE (INNER AND OUTER CV JOINT) REMAVAL/
INSPECTION (4X4)
NOTE
The outer CV joint cannot be disassembled or repaired, if damage or faulty the drive axle
assembly must be replace.
1. Drive axle/ outer CV joint assembly.
2. Boot band "A".
3. Outer board boot.
4. Boot band "B".
5. Stopper ring
6. Outer CV joint *
7. Circlip
8. Bearing *
9. stopper ring
10. Inboard boot.
NOTE: Always order and replace 6 and 8 together.
REMOVAL
1. Place the vehicle on level ground and set
the parking brake, Block the rear wheels so
the vehicle will not roll in either direction.
2. Remove the front wheels, steering tie rods,
disconnect the A arm on the ball joint end
as described in this Chapter and Chapter
4.
CAUTION
To avoid damage to the front differential
oil seal, hold the front drive shaft
horizontal and straight out from the front
differential during removal.
LH500ATV-D T3 EFI SERVICE MANUAL 19.0
CHAPTER 5 FINAL DRIVE. 5- 6