Specifi Cations; Power Input Requirements; Operating Environment; Regulatory - 3M Tape Application Monitor Instructions And Parts List

Specifi cations

The 3M-Matic™ Tape Application Monitor has been designed and tested to work with the following 3M-Matic™
case sealers: 200a, 800ab, 800asb, 800r, 800rks, 800rf, 7000a, 7000r, 8000a, and 8000af.
Additional information is required for 800rks and 800rf applications. Contact a 3M representative for more detail.
* 800r applications require additional machine modifi cations for proper operation.
(Contact the 3M-Matic Help Line)
Note: Components required to confi gure this system to monitor either an upper or lower taping head have been
included. Additional components are required for outboard tape supply roll applications.
An optional conversion kit is available.
Power Requirements:
Input: 115 VAC, 10A, 60 Hz, 1 Phase
Cord connected, NEMA 5-15R, 3 pin 115 VAC outlet
Output: (3M-Matic™ case sealers control):
Solid state relay, Normally closed, 115/230 VAC, 25 amp rating, protected by
10 amp power switch/circuit breaker, open when:

Operating Environment:

NEMA 1
For use in dry, relatively clean environments at 35 – 120 deg F [2 – 48 deg C] temperatures
Important: Control box with components should not be washed down or subjected to conditions
causing moisture condensation on components.

Regulatory

USA Standard Code of Regulations: FCC Part 15, Subpart B, Class A cUL 508A

Control

PLC (Keyence KV-N14AR) with key features:
Human Machine Interface Display (HMI)
(Keyence VT3-W4M) display for setting program parameters/displaying faults
Inputs: NPN/PNP 24VDC with LED indicators, Qty 8 (6 reserved, 2 spares)
Outputs: Relay with LED indicators, Qty 6 (4 Reserved, 1 Spare 24VDC, 1 Spare AC line voltage)
Power Supply: Internal switch mode 24 VDC 600ma
TAM Application Monitor - Yype 21800
Page 6
44-0009-2048-6 / ECO# 0078483
North American - ENG
Date Released:
05-22-18