ZyXEL Communications Prestige 480 User Manual page 128

Prestige 480 Dual BRI ISDN Router
Callback Budget
Management:
Allocated Budget This field sets the budget callback time for all the remote dial-in users.
(min) The default for this field is 0 for no budget control.
Period (hr) This field sets the time interval to reset the above callback budget
control.
IP Address
Supplied By:
Dial-in User If set to Yes, the Prestige will allow a remote host to specify its own IP
address.
If set to No, the remote host must use the IP address assigned by your
Prestige from the IP pool, configured below. This is to prevent the
remote host from using an invalid IP address and potentially disrupting
the whole network.
IP Pool This field tells your Prestige to provide the remote host with an IP
address from the pool. This field is required if IP Address Supplied
By: Dial-in User is set to No. You can configure this field even if Dial-
in User is set to Yes, in which case your Prestige will accept the IP
address if the remote peer specifies one; otherwise, an IP address is
assigned from the pool.
IP Pool: IP Start This field is applicable only if you selected Yes in the Dial-In IP
Addr Address Supplied By: IP Pool field.
The IP pool contains contiguous IP addresses and this field specifies
the first one in the pool.
IP Count (1,4) In this field, enter the number (1 or 4,) of addresses in the IP Pool. For
example, if the starting address is 192.168.135.5 and the count is 4,
then the pool will have 192.68.135.5 and 192.68.135.8
Session Options: Press Yes, then [Enter] to edit the filter sets. Keep in mind that the
filter set(s) will only apply to remote dial-in users but not the remote
Edit Filter
nodes.
Sets
Note that spaces and [-] symbol, are accepted in this field. For more
information on customizing your filter sets, see Chapter 9 - Filter
Configuration. The default is blank, i.e., no filters.
Once you have completed filling in Menu 13 - Default Dial-in Setup, press [Enter] at the message [Press
ENTER to Confirm...] to save your configuration, or press [Esc] at any time to cancel.
8-6
Default = 0
(Default =
Yes)
Yes/No
Yes/No
(Default =
No)
1, 4
Dial-In Server Configuration