ZyXEL Communications Prestige 480 User Manual page 119

Prestige 480 Dual BRI ISDN Router
Step 2. Move the cursor to the Edit IP/IPX/Bridge field, then press the space bar to select Yes and press
IP Options:
Rem IP Addr:0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
Single User Account= Yes
Metric= 2
Private= No
RIP Direction= Both
[Enter] to open Menu 11.3 - Network Layer Options.
The following table describes the bridging-specific parameters in the Remote Node Profile and Network
Layers menus.
Field
Bridge
Edit IP/IPX/Bridge
Dial-On-Broadcast
Ethernet Addr
Timeout (min)
Bridging Setup
Menu 11.3 - Remote Node Network Layer Options
Version= RIP -2B
Enter here to CONFIRM or ESC to CANCEL:
Menu 11.3 - Remote Node Bridging Options
Remote Node Network Layers Menu Bridge Options
Description
Make sure this field is set to Yes.
Press the space bar to change it to Yes and press [Enter] to go to the Network
Layer Options Menu.
This field is necessary for your Prestige on the caller side LAN. When set to Yes,
any broadcasts coming from the LAN will trigger your Prestige to make a call to
this remote node. If it is set to No, your Prestige will not make the outgoing call.
In this field, enter the time (number of minutes) that you wish your Prestige to
retain the Ethernet Addr information in its internal tables while the line is down. If
IPX Options:
Dial-On-Query= N/A
Rem LAN Net #= N/A
My WAN Net #= N/A
Hop Count= N/A
Tick Count= N/A
W/D Spoofing(min)= N/A
SAP/RIP Timeout(min)= N/A
Bridge Options:
Dial-On-Broadcast= No
Ethernet Addr Timeout(min)= 0
7-3