ZyXEL Communications Prestige 480 User Manual page 90

Prestige 480 Dual BRI ISDN Router
Outgoing: My Login
Name
Outgoing: My
Password
Outgoing: Authen
Outgoing: Pri(mary)
Sec(onda
ry) Phone
Numbers
Edit PPP Options
Rem IP Addr
Telco Options:
Allocated Budget (min)
Period (hr)
Transfer Type
4-4
This field determines whether or not your Prestige will call back
after receiving a call from this remote node.
If this option is enabled, your Prestige will disconnect the initial
call from this node and call it back at the Outgoing Primary
Phone Number (see below).
This is a required field [?] if Call Direction is either Both or
Outgoing. Enter the login name for your Prestige when it calls
this remote node.
This is a required field [?] if Call Direction is either Both or
Outgoing. Enter the password for your Prestige when it calls this
remote node.
This field sets the authentication protocol used for outgoing calls.
Options for this field are:
CHAP/PAP - Your Prestige will accept either CHAP or PAP
when requested by this remote node.
CHAP - accept CHAP only.
PAP - accept PAP only.
Your Prestige always calls this remote node using the Primary
Phone number first for a dial-up line.
If the Primary Phone number is busy or does not answer, your
Prestige will dial the Secondary Phone number if available.
Some areas require dialing the pound sign # before the phone
number for local calls. A # symbol may be included at the
beginning of the phone numbers as required.
To edit the PPP options for this remote node, move the cursor to
this field, use the space bar to select Yes and press [Enter]. This
will bring you to Menu 11.2 - Remote Node PPP Options. For
more information on configuring PPP options, see the section
Editing PPP Options.
Enter the IP address of the remote gateway.
This field sets a ceiling for outgoing call time for this remote
node. The default for this field is 0 for no budget control.
This field sets the time interval to reset the above outgoing call
budget control.
This field specifies the type of connection between the Prestige
and this remote node. When set to Leased, the Allocated
CHAP/ PAP
CHAP
Press space
bar to toggle
Yes then
[Enter]
Default = 0
Remote Node Configuration
PAP
press
64k/