This chapter shows you how to configure your G-202 in access point mode.
5.1 Access Point Mode Introduction
To set your G-202 as an Access Point (AP), select AP Mode in any utility screen (refer to
Section 1.2.4 on page
In access point mode, your G-202 functions as an access point. This allows you to set up your
wireless networks without using a dedicated AP.
Note: At the time of writing this function is not available on Windows Vista.
5.1.1 ZyXEL Utility Screen Summary
This section describes the ZyXEL utility screens when the G-202 is in AP mode.
Figure 47 ZyXEL Utility Menu Summary: AP Mode
The following table describes the menus.
Table 15 ZyXEL Utility Menu Summary: AP Mode
TAB
AP Mode
Link Info
Configuration
MAC Filter
Chapter 5 Access Point Mode Configuration
Access Point Mode
23).
DESCRIPTION
Use this screen to see your current connection status, configuration and data rate
statistics.
Use this screen to configure wireless LAN settings.
Use this screen to configure which computer(s) you want access to the wireless
LAN through the G-202.
ZyXEL G-202 User's Guide
C
H A P T E R
Configuration
5
73