Important Notes - Swagman 64684 Instruction Sheet

INSTRUCTION SHEET
PRODUCT: 64684 Dispatch 2 Bike Rack
• Page 2 of 3
3. Fold the upright bar back into the upright position. You should hear a click to
indicate the cam is engaged. NOTE: You may have to tilt the bike towards the
vehicle to make it easier to fold the ratchet bar upright.
4. Push the longer hook down onto the bike. Press the release button on the hook
to slide it more easily into place. Release the button when the hook is securely
holding the bike. Releasing the button locks the hook in place and prevents
it from any upward movement while in transit. Ensure the hook arm is fully
locked into the notches on the upright arm. NOTE: You should always ensure
that the hook is located in the lowest position on the top tube. It is usually at
connection point of the top tube and the seat tube. (Diagram 8)
5. Install the outside bike in the same manner using the short hook. NOTE: After
complete installation check all pins and tighten knobs to ensure they are all
tight and that the bikes are motionless in the rack.
ensure that all of the wheel straps are attached and secure. (Diagram 9)

IMPORTANT NOTES:

• T his bicycle rack has been designed to carry 1 or 2 bikes. It can only be used in a
Class 3 or Class 4 hitch.
• This rack is designed for typical use and applications (on paved or smooth
gravel roads). Do not use this rack on a vehicle that will be driven on rough
roads or where the rack (and bikes) will be subject to significant or constant
jarring and/or shock, or any vehicle with very stiff springs that will transfer the
load shock directly to the rack and bikes.
• Proper fitting and installation of this carrier to your specific vehicle is critical,
and is not the manufacturer's responsibility.
• Improper use of this product may result in damage to your rack, your vehicle,
your bicycles, or even other vehicles driving behind you as a result of colliding
with or trying to avoid fallen bicycles and/or the rack.
• The purchaser should be aware that the load created by a rack and bicycles can
exceed the maximum rating on the hitch or bumper.
• Swagman Racks are powder coated to help prevent rust. When leaving
them outside for extended periods of time the finish will lose its luster. It is
recommended that when not in use it is stored indoors.
• Take care to add padding on any area of the bikes that touches another bike
or any part of the vehicle. Damage can and will happen (to your bikes and/or
to the vehicle) if care is not taken during the loading and transporting of your
bikes, and padding used where necessary.
• Bicycle tires should be kept at least 6" away from the exhaust pipes of the
vehicle. The high temperature exhaust exiting from the exhaust pipes is hot
enough to melt or damage tires. The bike rack should also be kept away from the
direct exhaust flow. Also check when the bike rack is folded up.
300 - 1880 Government St. • Penticton, B.C. Canada V2A 7J1 • Phone (250) 490-8883 • Fax (250) 490-8885 • www.swagman.net
IMPORTANT:
You have to
5
7
6
8
9
Tighten wheel straps
REV 23/10/19