Swagman 64675 Instruction Sheet

PRODUCT: 64675 4 Bike Original Rack - Towing Fold Down 2" Receiver • Page 1 of 2
INSTRUCTIONS:
1. Assembling the 4 Bike Rack (diagram 1).
a. Slide rack 'C' into collar 'B' . Secure in place with 12mm x 80mm bolt, washers and lock nut.
b. Torque the nut using a 18mm wrench. It should be tight enough to allow for movement of the
rack in the collar to fold down as required. NOTE: The locknuts are a special machine nut, they
require force to tighten.
c. Periodically check to make sure that the bolt and lock nut are secure.
d. Place a 1/2" Pin and clip through the top hole.
e. Slide the receiver piece 'A' into collar 'B' . Secure in place with two 12mm x 80mm bolts and lock nuts.
f. Torque the nuts on tightly using a 18mm wrench (60 ft/lbs).
g. Periodically check to make sure that the bolts and lock nuts are secure.
2. Place your rack receiver into your receiver hitch (diagram 2).
3. Secure your rack with the hitch pin and clip.
4. Check to ensure rack is secure and safety pin is in place.
5. To remove top plate, undo captured knobs on your rack. Remove top plate. Place bike top tubes
in vinyl grooves so that they are balanced as shown in diagram 3. (Sloping top tube bikes may
sit on an angle).
6. After placing a maximum of 4 bikes on your rack, replace top plate and tighten knobs evenly.
NOTE: The tow ball should be a 3000 lb ball with a 3/4" shaft. It should be tightened to 75lbs torque.
IMPORTANT NOTES:
• This bicycle rack has been designed to carry 1, 2, 3, or 4 bikes.
• This rack is designed for typical use and applications (on paved or smooth gravel roads). Do not
use this rack on a vehicle that will be driven on rough roads or where the rack (and bikes) will be
subjected to significant or constant jarring and/or shock, or any vehicle with very stiff springs
that will transfer the load shocks directly to the rack and the bikes.
• Proper fitting and installation of this carrier to your specific vehicle is critical, and is the owners
sole responsibility.
• Improper use of this product may result in damage to your rack, your vehicle, your bicycles, or
even other vehicles driving behind you (as a result of colliding with or trying to avoid fallen
bicycles and/or the rack).
• The purchaser should be aware that the load created by a rack and bicycles can exceed the
maximum rating on the hitch or bumper.
• Swagman racks are powder coated to help prevent rust. When leaving them outside for extended
periods of time the finish will loose its luster. It is recommended that when not in use the rack is
stored indoors.
• This bike rack is designed for round tube frames no more then 30mm in diameter. The rack won't carry
bikes with oblong frame tubes or unusually large frame sizes.
• Take care to add padding on any area of the bikes that touches another bike or any part of the
vehicle. Damage can and will happen (to your bikes and/or to the vehicle) if care is not taken
during the loading and transporting of your bikes, and padding used where necessary.
Swagman • 300 - 1880 Government St. • Penticton, B.C. Canada V2A 7J1 • Phone (250) 490-8883 • Fax (250) 490-8885 • www.swagman.net
INSTRUCTION SHEET
1
2
3
Bike Mounting Options
Single Bike
Two Bikes
Three Bikes
Four Bikes
Oversized Tube
Standard Tube
REV 08/05/15