2Psk; Select 2Psk Modulation; Carrier Waveform Shape; Carrier Phase - Hantek HDG2000B Series User Manual

Sine: 1μHz to 100MHz
Square: 1μHz to 30MHz
Ramp: 1μHz to 4MHz
Pluse: 1μHz to 15MHz
Arb: 1μHz to 20MHz
Press Hopping to set the parameter. Use the numeric keyboard or direction keys and knob to
input the desired frequency value.

5.7 2PSK

You can configure the instrument to "shift" its output phase between two preset values using
2PSK modulation. The rate at which the output shifts between the two phases (called the "carrier
phase" and the "modulation phase") is determined by the internal signal level of the instrument or
the signal level on the front-panel [Sync/Mod/Trig] connector.

5.7.1 Select 2PSK Modulation

Press Mod->Type->2PSK to enable this function.
 When Mod is enabled, Sweep or Burst will be disabled automatically.
 After 2PSK is enabled, the instrument will generate 2PSK waveform with the currently specified
carrier and modulating waveforms. To avoid multiple waveform changes, enable modulation
after configuring the other modulation parameters.

5.7.2 Carrier Waveform Shape

2PSK carrier shape: Sine (default), Square, Ramp, Pulse, Arbitrary (except DC) or Harmonic
waveform.
 Press the front panel key Sine, Square, Ramp, Pulse, Arb -> Type or Harmonic to select a
desired carrier waveform shape.
 Noise and DC could not be used as carrier waveform.

5.7.3 Carrier Phase

Choose carrier waveform shape, press Phase to highlight "Phase", and then use the numeric
keyboard or direction keys and knob to input the desired phase. The available phase ranges from
0º to 360º and the default value is 0º .
User Manual 45