Table of Contents
Advertisement
Signal List
The signal list is shown as follows:
It displays the input module type, the quantity of inputs and input format. Right click the input for the
following settings:
Change Name: Select "New Name", and input the new name, click "OK" after setting.
Refresh Signals: Right click the input and select "Refresh Signals". If there is signal, it will show the
input format, or it will show "No Input".
Set Input Property: Right click the input and select "Input Property".
Set 4K signal source: Right click the input, select "4K", Choose "Input Module" and "Work Mode" and
Input 1 Type, then click "Set".
Layer split/merge: Right click the input, select layer split/ layer merge.
Output Setting
Click "Monitor" shortcut
. Enable or disable the quick split mode by sliding the quick split
switch and set H total, V total, Top Border, Bottom Border, Left Border, Righ Border, Row and Column.
EDID
© Xiamen RGBlink Science & Technology Co., Ltd.
34 / 46
Ph: +86 592 5771197 |
|
support@rgblink.com
www.rgblink.com
Advertisement
Table of Contents
