Presentation Mode(4K1K) - RGBlink D6 Quick Start Manual

Refresh Signals: Right click the input and select "Refresh Signals". If there is signal, it will show the
input format, or it will show "No Input".
Set Input Property: Right click the input and select "Input Property".
Set 4K signal source: Right click the input, select "4K", Choose "Input Module" and "Work Mode" and
Input 1 Type, then click "Set".
Layer split/merge: Right click the input, select layer split/ layer merge.
Output Setting
Click "Monitor" shortcut , it will enter the interface as follows:
Quick split: Enable or disable the quick split mode by sliding the quick split switch and set H total, V total,
Top Border, Bottom Border, Left Border, Righ Border, Row and Column.

Presentation Mode(4K1K)

Click "Operation Mode" and Choose "Presentation Mode (4K1K)"
© Xiamen RGBlink Science & Technology Co., Ltd.
29 / 46
Ph: +86 592 5771197 | |
support@rgblink.com www.rgblink.com