ARTHUR HOLM DB2 Series User Manual page 20

INSTALLATION INSTRUCTIONS
Option V1:
- Double side tape or glue used can't be thicker than 0,2-0,25mm [0.008
0.01]
1. Check if the Veneer fits perfectly with the monitor. To join both parts
correctly it is important that the two surfaces are touching each other in
the whole length. (To make easier the adjustment the height of the touch
button can be barely adjusted.)
2. Clean the top surface of the metal monitor housing and the bottom
surface of the Veneer.
3. Glue the Veneer. Double-side tape or glue can be used (depending on
the kind of materials are going to be jointed). The pressure applied must
not exceed 1 Kg evenly distributed on monitor surface.
20