Other Functions; Resetting The St-224 To The Factory Default (Initializing); Initializing Without Loading Backup Memory Data (Quick Start) - Zoom Sampletrak ST-224 Operation Manual

Resetting the ST-224 to the Factory Default (Initializing)

You can reset the unit to the factory default condition as follows.
EDIT 2
A
B
EFFECT SYNC
1
STEP Turn off the ST-224.
2
STEP While holding down the [SAVE] key, turn the unit back on again.
The indication "init" appears on the display.
To cancel the initialization, press the [EXIT] key.
3
Press the [SAVE] key again.
STEP
The ST-224 is reset to the factory default condition, and the
preprogrammed sound sources (samples) are loaded into the main
memory.
Proceed with care. When initialization is performed, all bulk data
NOTE
stored in the backup memory will be erased.

Initializing Without Loading Backup Memory Data (Quick Start)

Normally, the ST-224 loads data from backup memory into the main memory every time the unit is
turned on. This causes a certain delay until the unit can be used for playing or sampling. When wishing to
skip this step and get the unit ready for use quickly, perform the following steps.
EDIT 2
A
B
EFFECT SYNC
1
STEP
Hold down the [EXIT] key and turn the ST-224 on.
The ST-224 becomes ready for use immediately, because the loading
process from backup memory is skipped. The main memory will be
empty.

Other Functions

PLAYLIST
MEASURE
EFFECT COPY DELETE
TAP BPM
ON/OFF
BACKUP
EXIT
LOAD SAVE
AUTO SYNC
PAD ENABLE
PLAYLIST
MEASURE
EFFECT TAP COPY DELETE
BPM
ON/OFF
EXIT
LOAD
AUTO SYNC
PAD ENABLE
BEAT SAMPLE/SONG
RECORD PLAY/STOP
– +
PAD ASSIGN CAPACITY ERASE
INTERNAL/DATA CARD
SPECIAL
FUNCTION
PAD
SONG
LOAD
BEAT SAMPLE/SONG
RECORD PLAY/STOP
– +
BACKUP
PAD ASSIGN CAPACITY ERASE
SAVE
INTERNAL/DATA CARD SPECIAL
FUNCTION
PAD
SONG
OPTIMIZE
POWER
BACKUP
SAVE
INTERNAL/DATA CARD
POWER
BACKUP
LOAD SAVE
INTERNAL/DATA CARD
OPTIMIZE
EXIT
POWER
69