Table of Contents
Advertisement
Quick Guide (4) Try Out Sampling
In Quick Guide (2), you played samples that were already preprogrammed in the unit. Now let's try out
assigning a sampled sound to a pad yourself. The following description shows how to use the supplied
sampling CD to sample drum and percussion sounds and assign the samples to pads.
[Preparations ]
• Connect the ST-224 to the playback equipment (
• Connect the CD player output jacks to the [INPUT R] and [INPUT L/MONO] jacks on the ST-224. Set the
[INPUT] knob of the ST-224 to a suitable position (
• Select a track from the CD which you want to sample and set the CD player to pause at the start of the
desired track.
Press the [RECORD] key.
The ST-224 goes into the sampling standby
mode, and the LED of the [RECORD] key
flashes.
RECORD
Press the [RECORD] key again
and then immediately release the
pause condition of the CD player
to start playback.
At the end of the passage that
you want to sample, press the
[PLAY/STOP] key.
14
p.
8).
p.
8).
POWER
DC IN
EFFECT
TIME STRETCH
VOLUME/BASS
SCRATCH
DELAY
REVERB
FLANGER
STEP CRY
CHORUS
PHASER
PITCH SHIFTER
LOW-PASS
DIMENSION
DISTORTION
RING MODULATOR
EDIT 2
A
B
EFFECT SYNC
EDIT 1
MIDI IN
DATA CARD
EXCITER
TREMOLO
BPM/VALUE
SONG
AUTO PAN
REC
PLAY/STOP
LO-FI EFFECT
COMPRESSOR
EXTREME EQ
RESONANCE
PLAYLIST
HIGH-PASS
EFFECT
COPY
TAP
BPM
ON/OFF
EXIT
AUTO SYNC
PAD ENABLE
L/MONO
R
PHON
OUTPUT
MEASURE
B
DELETE
BACK
LOAD
SAVE
INTE
4
OFFSET
SHIFT
LOOP/MARK
Advertisement
Table of Contents
