Table of Contents
Advertisement
While holding down the [PLAY/STOP] key, use the [-] and [+] keys to change the auto stop
5
STEP
sampling time
The value can be set in 1 second steps.
The auto sampling time can also be specified in BPM units. To do
HINT
HINT
this, hold down the [BPM] key and use the [-] and [+] keys to
change the time. The display will change to BPM units. The time
corresponding to four beats of the displayed BPM value will be the
auto sampling time. Pressing the [BPM] key again returns to the
normal display.
6
STEP
Press the [RECORD] key to start sampling.
• When auto recording mode is selected
Sampling starts as soon as the signal exceeds the preset trigger
level for the first time. Pressing the [PLAY/STOP] key stops
sampling.
Level
RECORD
When auto recording mode is used to sample a source with a slow
NOTE
attack curve, the beginning of an attack sound may be cut off.
• When auto stop mode is selected
Sampling starts according to the conditions set for auto recording
mode, and ends when the preset auto sampling time has elapsed.
Level
RECORD
HINT
HINT
Auto recording mode and auto stop mode can be used together.
7
STEP
Use the [PLAY/STOP] key to check the recorded sample.
By following steps 8 - 11 shown on
sample to a pad.
24
Trigger Level
Time
PLAY/STOP
Sampling start
Sampling end
Auto recording mode sampling
Time
Auto Sampling Time
Sampling start
Sampling end
Auto stop sampling
page
22, you can assign the
PLAY/STOP
–
[–] [+] keys
RECORD
Sample
Sample
PLAY/STOP
+
Advertisement
Table of Contents
