Formatting A Data Card - Zoom Sampletrak ST-224 Operation Manual

Formatting a Data Card

Before a data card can be used for saving and loading data, it must be formatted (initialized) as follows.
NOTE Use only data cards formatted in the ST-224.
EDIT 2
A
B
PAD ENABLE
EFFECT SYNC
1
STEP
Insert a data card into the [DATA CARD] slot on the rear panel of the unit.
• Insert the data card in such a way that the corner cutout
is on the far left side and the connector area faces
NOTE
towards the rear.
• If the card is not oriented properly, it will not go fully into
the slot. Forcefully pushing the card in may damage it.
2
Hold down the [SPECIAL] key and press the [INTERNAL/DATA CARD] key.
STEP
The indication "ForMAt" appears on the display.
If the indication "noCArd" appears, the data card is not recognized.
NOTE
Check whether the card has been inserted properly.
3
STEP Press the [INTERNAL/DATA CARD] key.
The display indication flashes and formatting starts. When formatting
is completed, the indication "FiniSH" appears on the display.
• When formatting is carried out, any data already stored on the
NOTE
card will be lost. Take care not to accidentally erase a card.
• If the indication "Cd Err" appears during formatting, there is a
problem with the data card. Repeat the process from step 1. If
the same error occurs again, use a different card.
4
STEP When formatting is completed, press the [EXIT] key.
The ST-224 reverts to the play mode.
NOTE
Cards formatted in other devices may not be usable in the ST-224.
60
MEASURE
EFFECT COPY DELETE
TAP BPM
ON/OFF
BACKUP
EXIT
LOAD SAVE
AUTO SYNC
BPM/VALUE
BEAT SAMPLE/SONG
RECORD PLAY/STOP
– +
PAD ASSIGN CAPACITY ERASE OPTIMIZE
INTERNAL/DATA CARD
SPECIAL
FUNCTION
PAD
SONG
ST-224 Rea Panel
OUTPUT
Data Card
SPECIAL
BPM/VALUE
MEASURE BEAT SAMPLE/SONG
MEASURE BEAT SAMPLE/SONG
DATA CARD
L/ MONO MIDI IN
BACKUP
+
LOAD SAVE
INTERNAL/DATA CARD
BACKUP
LOAD SAVE
INTERNAL/DATA CARD
EXIT