Playing Songs With Pads (Play List Function); Assigning Songs To Pads - Zoom Sampletrak ST-224 Operation Manual

Playing Songs With Pads (Play List Function)

The ST-224 incorporates a play list function which lets you assign songs 1 - 8 to pads 1 - 8 and play the songs
by hitting the pads. This section explains how to use this function.

Assigning Songs to Pads

TIME STRETCH
SCRATCH
DELAY
REVERB
FLANGER
STEP CRY
CHORUS
PHASER
PITCH SHIFTER
DIMENSION
EDIT 2
EDIT 1
1
STEP Record songs 1 - 8 to assign to the pads.
2
STEP
While the unit is in play mode, press the [PLAYLIST] key.
The ST-224 goes into play list mode. The [PLAYLIST] LED lights up
and the [BANK 1] - [BANK 3] LEDs go out. Songs 1 - 8 are now
assigned to pads 1 - 8 and can be played with the pads.
3
STEP Press one of pads 1 - 8.
The LED of the pad lights up and the song assigned to the pad is
played back in loop mode.
4
STEP To switch songs, hit another pad.
Only one song can be played at a time. If another pad is pressed
while a song is playing, the previous song stops and playback of the
new song starts.
5
STEP
To set song playback to the hold mode, press the [LOOP/MARK] pad.
The song continues to play also after the pad is released.
6
STEP
To terminate the play list mode, press the [PLAYLIST] key.
The [PLAYLIST] LED goes out and the unit reverts to normal play
mode.
Also during play list playback, the internal effects and the
HINT HINT
[SOURCE] pad for input source playback can be used.
56
VOLUME/BASS
EXCITER
TREMOLO
BPM/VALUE
SONG
AUTO PAN
REC PLAY/STOP
LO-FI EFFECT
COMPRESSOR
EXTREME EQ
RESONANCE
PLAYLIST
LOW-PASS
HIGH-PASS
DISTORTION
RING MODULATOR
EFFECT COPY DELETE
TAP BPM
A
B
ON/OFF
EXIT
AUTO SYNC
PAD ENABLE
EFFECT SYNC
4
LOOP/MARK
SAMPLING
MONO
GRADE
STEREO
MEASURE BEAT SAMPLE/SONG
RECORD
– +
BACKUP
PAD ASSIGN CAPACITY
LOAD SAVE INTERNAL/DATA CARD
SPECIAL
OFFSET
SHIFT
RE-SAMPLE
PLAY/STOP
ERASE OPTIMIZE
FUNCTION
PAD
SONG
1
BANK
2
BANK
3
BANK
PLAYLIST
Pads 1 – 8
Pads 1 – 8
[LOOP/MARK] pad
LOOP/MARK
PLAYLIST