Storing - Gastroback DESIGN ESPRESSO ADVANCED PROFESSIONAL Operating Instructions Manual

STORING

WARNING:
Young children must be supervised that they do not play with the appli-
ance or any part or accessory of it. When the appliance is not in use, always switch
OFF (press POWER button), and unplug the appliance. Always leave the appliance cool
down, before cleaning or storing the appliance. Only store the appliance where it is
protected against inadmissible strain (e.g. moisture, electric or mechanic shock, frost,
direct sunlight) and out of reach of young children.
CAUTION:
Do not grasp the appliance at the group head, drip tray, bean hopper, or
power cord for moving. Always grasp the appliance at both sides at the bottom of the
base for moving it. Ensure to store the appliance in upright position where it is clean and
dry. Do not place any hard or heavy objects on or in the appliance or any part of it.
Do not open the boiler valves (DESCALE ACCESS) while the appliance is still hot to avoid
risk of scalds and damage. Always allow cooling for at least 1 hour prior to opening the
boiler valves.
The power cord may not be knotted, squeezed or bent. Do not pull or strain the power
cord.
Note:
When opening the boiler valves, the drip tray will fill with water. Ensure to empty the
drip tray before opening the boiler valves to avoid overflow. We recommend draining
both boilers completely before transporting the machine or storing for an extended peri-
od of time. This procedure is also intended as an anti-freeze measure in the event the
machine is exposed to extreme cold temperatures.
1. Empty the bean hopper and the grinder. See: ›Cleaning the Burrs‹.
2. Switch OFF the appliance (press POWER button), unplug, and leave cool down
completely (at least 1 hour). Clean the appliance and all parts and accessories (see:
›Care and Cleaning‹).
3. Empty the water tank and remove the water filter. Then replace the filter holder and
lock the water tank back into position. Empty the drip tray and, thereafter, insert it
back into position. Place a cloth over the drip tray to stop steam escaping.
4. Remove the grey silicone cover on the lower front marked DESCALE ACCESS.
Beware of hot steam and water, while rotating the screws counter-clockwise until
the valves are fully open. For this, use a flat-head screwdriver. As the valves open,
steam may be released. Wait until no more water or steam escapes.
CAUTION:
The drip tray may be hot.
IMPORTANT: Do not over tighten the screws to avoid damaging the valves.
5. Close both valves by rotating screws clock-wise carefully just until seated. Replace
the grey silicone cover over the valves.
117