Table of Contents
Advertisement
Prepping
the Cabinet/
Drawer Face
1. Separate Strike Plate Template.
2. ESTABLISH CENTERLINE (for
double door cabinet see Double
Door Prepping, next page).
3. MEASURE cabinet wall thickness
and mark offset line on face of
cabinet/drawer. The offset line
should match with the interior
edge of the cabinet wall.
4. CONTINUE CENTERLINE to
the face of cabinet/drawer.
5. ALIGN template to offset
line and centerline. Remove
backing an apply template
onto cabinet/drawer face.
6. Use punch to mark drilling
locations, then drill mounting
holes. If using mechanical
Key override, drill key
override hole as well.
4 of 12
Diagram 3: Installation Template
Diagram 4: Prepping
Strike Plate
Template
CTR Line
Offset Line
Advertisement
Table of Contents
