Mounting The Sanding Table; Sanding Belt Board - Westfalia 85 46 55 Original Instructions Manual

Mounting the Sanding Table (Fig. 1-2)
1. Make sure the motor is switched
off.
2. Thread the sanding belt (28)
through
sanding table (41).
3. Tighten the sanding table with
the compatible screw and wash-
er onto the screw that sticks out
from the housing. The locking
handle (43) is still assembled. It
is spring loaded and can be
repositioned. If you pull out the
handle you can change the
position of the handle without
moving the inside thread bar.
Sanding Belt Board (Fig. 3)
The limit plate (22) protects the work
piece during sanding.
1. Mount the limit plate so that the
limit plate touches the backside of
the sanding belt. To adjust, un-
screw both screws (24).
2. Adjust the limit plate and tighten
the screws (24) again.
For work such as polishing or
sanding bent pieces remove the limit
plate.
the opening
Operation
Opening
in the
22
Fig. 1
43
Fig. 2
Fig. 3
22
28
41
24