Sanding Dish Cover And Sanding Dish - Westfalia 85 46 55 Original Instructions Manual

The bottom side of the screw should slightly touch the plate
underneath the table. Now you can reposition the table to
exactly 90° angle without new adjustment.
4. The sanding table can be mounted in different angles to the
belt. Loosen the locking handle (43) and tilt the table up to the
required angle. The table edge is situated in front of the belt
but too far from the belt.
5. Therefore, slowly push the table in direction to the belt
observing the required incline. For safety use, the gap be-
tween the table edge and the belt should not be higher than
2 mm. After adjustment, tighten the locking handle (43) again.
Sanding Dish Cover (56) and Sanding Disc Table (64) (Fig. 6-7)
1. Make sure the motor is
switched off.
2. Mount the sanding dish
cover (56) with the four
enclosed screws (21) and
the four flat washers (23).
3. Mount the sanding dish
table on the sanding dish
guard (71).
4. On both sides of the disc
end shield (71) there are
two angular notches. Push
both hooks that are on the
inner side of the table into
these notches. These two
hooks are the centre of
rotation for the table.
Operation
21+23
62
63
24
Fig. 6
56
Fig. 7
71
64
66