Connecting; Dismounting - IBA ibaMS16xAO-10V/-20mA Manual

ibaMS16xAO-10V/-20mA
6.2

Connecting

Note
The backplane unit and the device must be connected to a protective conductor.
1. Connect all cables.
2. If all required cables are connected, connect the central unit to the power supply.
3. Switch on the central unit.
Note
When switching on and off the power supply or the central unit, it may be possible that
intermediate values are wrong at the analog outputs for approx. 5 seconds within the
output signal range.
6.3

Dismounting

1. Disconnect the central unit from the power supply.
2. Remove all cables.
3. Remove the both fixing screws on the upper and the lower side of the device.
4. Pull the device straight from the backplane.
5. Put the cover on the backplane bus.
Manual
Issue 1.4 11