Table of Contents
Advertisement
7.3.2
Overload protection
The outputs are protected against short circuits. Nevertheless a hardware error may oc-
cur, e. g. when the wiring is not correct.
When there is a hardware error, e. g. overtemperature, all channels of a signal root are
set to "safe state" (0 V or 0 mA). The error must be reset by "ResetError_Ch[00..15]" in
ibaLogic or "Reset channel errors" in ibaPDA (see also chapter 9.1.2).
7.3.3
Connection diagram / pin assignment
Here you can connect 16 output signals (0...15), each bipolar plus ground. 4 separated
galvanically isolated groups have 4 outputs each.
Figure 3:
14
ibaMS16xAO-10V
Connection diagram
Manual
Issue 1.4
ibaMS16xAO-10V/-20mA
ibaMS16xAO-20mA
Advertisement
Table of Contents
