Troubleshooting - Whirlpool 8LIECH-SCSSFP5W User Manual

TROUBLESHOOTING

Dispenser is not operating.
• Make sure that the power cord is properly connected to a working outlet.
• Confirm that power switches located in the back of unit are ON. They will glow
in the ON position if they are on.
• Turn them OFF and ON to make sure that cooler is plugged in and circuit
breaker is not tripped. If needed, plug power cord into another receptacle to
confirm there is electricity going to the water cooler.
Water is leaking.
Replace water bottle. Most common cause is a cracked bottle.
•
• If the leak remains, remove the probe from the bottle and call 1-844-494-4757 for assistance.
Push buttons are stuck.
• Apply mineral oil (baby oil) to the button slides to reduce friction.
No water is coming from the taps.
WARNING
Excessive Weight Hazard
Use two or more people to move and install bottles.
Failure to do so can result in back or other injury.
• Make sure the water bottle is not empty . If so, replace it. If not, adjust the probe to an appropriate
length. Refer to step 2 in " Cleaning Prior to Initial Use" section.
• Make sure that you fully press the water controls.
• Make sure that the probe connection with the water bottle forms a complete seal.
• Make sure that the door is closed.
Water dispensed is not cold.
It takes up to 6 hours after setup to dispense coldest water. Compressor works to build up ice
bank, this is normal.
• Make sure that the back of the dispenser is at least 4 inches from a wall and that air is free to
flow on all 4 sides of the dispenser.
• Make sure that the cold water switch is ON.
Water dispensed is not hot.
It takes 15-20 minutes after setup to dispense hot water.
• Make sure that the power cord is properly connected to a working outlet.
• Make sure that the hot water switch is ON.
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-844-494-4757 for assistance.
Model # 8LIECH-SCSSFP5W: Page 15