Unpacking And Assembly; Installation - Whirlpool 8LIECH-SCSSFP5W User Manual

UNPACKING AND ASSEMBLY

Remove the dispenser from packaging:
TO OPEN:
TOP
1. Lay dispenser on its side.
2. Open bottom flaps of the cardboard box.
3. Stand cooler up with flaps unfolded.
4. Pull box straight up.
5. Unpack the drip tray and insert it into the dispenser.
6. Keep original packing for the duration of warranty.

INSTALLATION

WARNING
Excessive Weight Hazard
Use two or more people to move and install bottles.
Failure to do so can result in back or other injury.
1. Place the dispenser on a hard and level surface in a cool
shaded location near a grounded wall outlet.
Notice: Do NOT plug in the power cord yet.
2. Position dispenser so that the back is at least 4 inches from
the wall and there are at least 4 inches of clearance on both
sides.
3. To minimize vibration and noise, make sure that the
dispenser is flat.
Notice: Do NOT plug in power cord yet.
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-844-494-4757 for assistance.
TOP
TOP
Use two or more people to move and install the
water cooler and the bottles.
Failure to do so can result in back or other injury.
Model # 8LIECH-SCSSFP5W: Page 6
WARNING
Excessive Weight Hazard