Whirlpool 8LIECH-SCSSFP5W User Manual page 9

NOTE: When using a 5 gallon rectangular bottle, slide it into place as shown in the illustration
below.
• If the probe tube A and B(see previous page) are not sealed, the pump will run a few min-
utes and the night lights will flash. To correct, open the door, re-attach the probe, and close
the door.
• If the lights continue to flash, your bottle may be empty or there may be an issue with the
water tube lines. Call 1-844-494-4757 for assistance.
3. Turn the switches at the back of the dispenser to ON.
• The red switch controls the hot water. If you do not want hot water, leave this switched
OFF.
• The blue switch controls the cold water. If you do not want cold water, leave this switched
OFF.
Note:
• For the unit to operate properly, the probe head must seal on the bottle and the door must
be fully closed.
• It will take up to 3 minutes for the reservoirs to fill with water. During this time, the pump will
run on and off. This is normal.
• Each time you dispense water from the taps, the pump will turn on to refill the tanks. This is
normal.
• Self Cleaning works every 4 hours for short time. Self Cleaning pump sound is normal.
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-844-494-4757 for assistance.
Model # 8LIECH-SCSSFP5W: Page 9