Troubleshooting - Whirlpool 7LIECK-W-WL User Manual

TROUBLESHOOTING

Dispenser is not operating.
• Make sure that the power cord is properly connected to a working outlet.
Water is leaking.
• Replace water bottle. Most common cause is a cracked bottle.
• Call 1-855-5WHIRL5 for assistance.
Push buttons are stuck and/or faucets are leaking.
• Apply mineral oil (baby oil) to the button slides to reduce friction.
No water is coming from the taps.
• Make sure that the bottle is not empty. If so, replace it.
• Make sure that you fully press the water controls.
Water dispensed is not cold.
• It takes up to 2 hours after setup to dispense coldest water.
• Make sure that the back of the dispenser is at least 4 inches from a wall and that air is free to
flow on all 4 sides of the dispenser.
• Make sure that the tank is not overfilled. Dispense water until bubbles appear in the bottle.
• Adjust the thermostat by turning it clockwise. Adjust in a single increment of 30 degrees of a
circle (the equivalent of 1 hour on a standard analog clock face). Wait 1 hour for the result. If
unsatisfactory, adjust another 30 degrees clockwise, wait, and then assess results. The
thermostat is located at back of unit.
Dispenser is noisy.
• Make sure that the dispenser is positioned on a level surface.
Water tastes bad.
• Drain the water from the reservoirs and replace the bottle with a fresh one.
• Clean dispenser per Proper Care & Cleaning instructions.
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-855-5WHIRL5 for assistance.
Model # 7LIECK-W-WL: Page 14