Troubleshooting - Ispring WSP-ARB User Manual

• Buildup on the filter mesh can affect water output. If normal scraping or rinsing
doesn't remove the buildup, we recommend removing the filter assembly.
• To remove the filter assembly, unscrew the filter housing counterclockwise using
the included wrench.
• Remove the filter assembly and clean the filter mesh.
Note: You do not need to remove the scraping assembly if you're only cleaning the
INSTALLING THE SCRAPING AND FILTER ASSEMBLIES
• To insert the scraping assembly into the filter housing, place the
quadrilateral hole with rounded corners into the hexagonal hole
on the bottom of the filter housing, and insert it into the bottom.
• When installing the filter assembly, align the four 'bumps' inside
the scraper assembly with the four grooves on the upper filter
housing, and insert it into the bottom.
Issue
No water
Low outlet flow
Water leakage at the joint
Does not display pressure
values
filter assembly.

TROUBLESHOOTING

Possible Causes
Water source doesn't have water.
Inlet water valve isn't open.
Inlet water valve isn't fully open.
Surface of the filter is partially
blocked.
Filter parts have been
disassembled.
Loose parts at the leaking location
Not enough Teflon tape on the
threads.
O-rings at the leaking location are
damaged.
Pressure gauge is damaged.
Inlet water valve isn't open.
Solutions
Wait for water to come back on
Open the inlet valve
Fully open the inlet valve
Flush the filter mesh to remove debris
Check to see if the seal is misaligned
or missing.
Retighten the threaded joint with a
wrench.
Reapply plumber's tape and tighten.
Replace O-rings.
Replace pressure gauge.
Open the inlet valve.