Table of Contents
Advertisement
ISSUE
Unit fails to initiate a
regeneration cycle
Low water pressure
Control valve without
display
Poor water quality
www.123filter.com
Troubleshooting
POSSIBLE CAUSE
No power supply
Power failure
Iron or scale builds up in line
feeding unit
Iron build up inside the valve or tank Clean control and add resin
Inlet of control plugged due to
foreign material
Power failure, the power adapter is
not plugged in
Power off while regeneration
Control valve failure
The Control valve clock is
inaccurate due to a power failure,
causing the regeneration start time to
be changed
Poor water quality
Filter failure
Regenerate too often or too little
Incoming water quality does not
meet national municipal tap water
standards
| (678) 261-7611 |
POSSIBLE SOLUTION
Check electrical service, fuse,
etc.
Reset time.
Clean pipes.
cleaner to clean bed. Increase
regeneration frequency.
Remove the piston and clean the
control valve.
Check the power supply to
ensure regular or restored
power supply.
Turn the bypass valve to the
bypass position or close the
control valve.
Contact dealer.
Adjust the control valve's
current time. For operating
procedures, refer to the current
time in the control valve
manual.
Add one regeneration process.
Refer to the setting of the
regeneration cycle in the
control valve manual for the
operating procedure.
Change the filter or contact
your dealer.
The regeneration cycle setting
is not optimal. Adjust the
regeneration cycle of the
control valve and refer to the
setting of the regeneration cycle
in the control valve manual for
the operating procedure.
Contact the relevant local water
supply department.
support@123filter.com
Page 22
Advertisement
Table of Contents
