Troubleshooting - Ispring CU-A4 Installation Instructions & Operating Manual

③ Installing the unit and filter cartridges
3.1 Match the stage labels and twist filter cartridges clockwise into the machine head in order.
3.2 On the cabinet wall, mark the two holes of the bracket and install two #8 x 1" round head
screws to hang the unit.
④ Installing the tubing (check Quick Tips for using Quick-fitting)
4.1 Connect the blue tubing with AFW, red tubing with 1
4.2 Check water route: cold water valve → blue tubing → drinking faucet valve → red tubing
→ 1,2,3,4 stages → white tubing → drinking faucet.
⑤ System startup
5.1 With a towel or bucket underneath, slowly turn on the Cold Water Valve, feel the vibration
and noise of the water flow. If your water pressure is high, DO NOT turn the Inlet Water
Valve all the way up, but sparingly to a level position.
5.2 If it leaks, check if the tubing is fully inserted into quick-fittings and that the nuts and
cartridges are properly tightened.
5.3 Turn on the Drinking Faucet. Water should start flowing. Let it run for 5 - 15 minutes or
until carbon particles are flushed out and water turns clear. The water filter is now ready for
use. Write down the current date on cartridge for future reference. The cartridge set has a
life span of about 6 – 9 months depending on water quality and usage.
⑥ Filter Replacement
6.1 Turn off the inlet water ball valve (COLD) and open the kitchen and drinking faucets to
release pressure.
6.2 With a towel or bucket underneath, twist the filter cartridge wrench counterclockwise to
remove and immediately put the replacement back on. Work in the order from the 1
th
to the 4 stage, which is from right to left when facing the front label of the machine head.
Symptom
No clean water
from the faucet
Slow water
flow
No water from
the fridge
www.123filter.com

Troubleshooting

Reason
1. No water or water pressure < 20 psi
2. Incorrect tubing connections
3. Drinking faucet is off
1. Water pressure lower than 20 psi
2. Filter cartridges are due for
replacement
st
3. 1 stage is clogged by sediments
Using the included faucet with an ice
maker kit to connect to the fridge
| (678) 261-7611 |
st
stage, white tubing with 4
Resolution
1. Check water source
2. Check the tubing connections
3. Check the faucet
1. Open kitchen faucet to check cold
water pressure
2. Check the installation date and
replacement schedule
3. A whole-house sediment filter is
needed to protect water appliances
Get iSpring ICEK fridge connector
to connect your ice maker to water
filter
support@123filter.com
th
stage.
st
stage
Page 8