Part 2 - Rotating The Voltage Selector In The Power Chassis; Figure 6-2. Insulating Blue Wire In Power Cord (200-240 Vac); Figure 6-3. Changing Voltage In Power Chassis - adept technology PA-4 Series User Manual

Chapter 6 - Maintenance
power cord from
power chassis
7 mm (1/4 inch)
shrink tubing

Figure 6-2. Insulating Blue Wire in Power Cord (200-240 VAC)

Part 2 – Rotating the Voltage Selector in the Power Chassis
1. Open the front air-intake grill on the power chassis by loosening two screws and
swinging the grill out.
2. Inspect the voltage setting; it is marked on the front of the voltage selector plug.
To change the voltage setting, remove the selector, rotate it 180 degrees so the
required setting is shown, and re-install it. See
3. Close the grill and secure the two screws.
4. Clearly mark or alter the ID label, which is located on the side of the PA-4 chassis,
to show the new voltage configuration (see
Adept PA-4 Power Chassis with Front Air Intake Grill Removed
adept
technology, inc.

Figure 6-3. Changing Voltage in Power Chassis

52 Adept PA-4 Power Chassis User's Guide, Rev E
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
19 mm (3/4 inch)
shrink tubing
Figure 1-2 on page
380–415 V~
Voltage Selector Plug
Voltage Selector
(in 380 – 415 V~ position)
Socket
blue wire
Figure 6-3.
11).
380–415 V~
200–240 V~