Figure 2-1. Installing Mounting Brackets On An Adept Pa-4 Chassis - adept technology PA-4 Series User Manual

To Install Mounting Brackets on Adept PA-4
Power Chassis:
• Remove (and discard) 3 existing countersunk
screws from side of chassis at locations shown
in drawing.
• Place bracket in desired position and secure
with M4 pan-head screws and washers from
accessories kit where indicated in drawing.
• Repeat process for other side of chassis.
M4 x 10 mm pan-head screw
(2 places)
M4 x 10 mm pan-head screw
Rack Mount – Flush

Figure 2-1. Installing Mounting Brackets on an Adept PA-4 Chassis

NOTE: See Section 2.3 on page 22
Adept PA-4 Power Chassis User's Guide, Rev E
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Space Around the Chassis
M4 x 10 mm pan-head screw
(2 places)
M4 x 10 mm pan-head screw
Panel Mount
M4 x 10 mm pan-head screw
(2 places)
M4 x 10 mm pan-head screw
Rack Mount – Set-Back
for PA-4 dimensions.
21