Panel Or Rack Mounting; Panel Mounting; Rack Mounting - adept technology PA-4 Series User Manual

Chapter 2 - Mounting the PA-4 Chassis
2.2

Panel or Rack Mounting

The PA-4 chassis can be panel or rack mounted using the optional mounting brackets
(P/N 90336-31030F). The brackets can be attached at the rear of the PA-4 chassis for panel
mounting, or they can be attached to the front of the PA-4 chassis for rack mounting.

Panel Mounting

To panel-mount the PA-4 chassis, install one bracket on each side near the back of the
chassis. Use the screws and washers from the accessories kit (see

Rack Mounting

Use the mounting brackets, screws, and washers to rack-mount the PA-4 chassis in a
standard 19-inch equipment rack. You must build an extender panel and attach it to the
mounting brackets. The brackets can be installed in two positions for rack mounting:
"flush" and "set-back" (see
NOTE: The rack-mount "flush" option is not available for PA-4 power
chassis shipped with Adept Viper and Cobra s850 systems. These
systems must use the "set-back" or "panel-mount" options.
20 Adept PA-4 Power Chassis User's Guide, Rev E
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
WARNING: Do not use screws other than those supplied.
There is a printed circuit board located at the bottom of the
chassis. Using screws longer than those supplied could
cause an electrical short, damage electrical components, or
pinch wires.
Figure 2-1 on page
Figure 2-1 on page
21).
21).