Removing The Interface Box; Figure 3-8. Pa-4 With Interface Box Tilted Open - adept technology PA-4 Series User Manual

The mating connector is supplied in the accessory kit. Adept part number:
05180-000, PLUG, MALE, 4P, MICRO (M12), M12X1 THREAD
Third party vendors for the mating connector:
• Lumberg, part #: RSC 4/9
• Mencom, part #: MDC-4MP-FWX
NOTE: The PA-4 in Viper s1700 systems does not have an External Brake
connector.
3.5

Removing the Interface Box

1. Turn off the PA-4 power chassis and the SmartController.
2. Loosen the 3 latching screws at the top of the Interface Box. See
page 26.
3. Lift the Interface Box up slightly, and tilt it down. Be careful to avoid loosening
the copper-colored finger strip shielding. See

Figure 3-8. PA-4 with Interface Box Tilted Open

4. Disconnect all of the cables from the Interface Box wire harness to the PA-4
modules.
5. Remove the Interface Box and set it aside, so you have full access to the PA-4
modules.
Adept PA-4 Power Chassis User's Guide, Rev E
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Removing the Interface Box
Figure 3-1 on
Figure 3-8.
Finger strip
shielding
35