Advertisement
TapeStor 8GB Installation Manual
c
SCSI Host Adaptor
(termination enabled)
(termination enabled)
SCSI termination in a system
in which the tape drive is the
only SCSI device.
d
Note: Drive is upside down
SCSI Host Adaptor
(termination enabled)
(termination disabled)
(termination disabled)
Tape drive
(termination enabled)
SCSI termination in a system
with three internal SCSI devices.
Pin 1
Jumper
Positions
Enable termination power (default is ON)
Enable active termination (default is ON)
Enable parity checking (default is ON)
Check SCSI termina
Check SCSI
Check SCSI
Check SCSI
Check SCSI
This tape drive is shipped with active SCSI termination
enabled. If the drive is the last or only device on the
SCSI cable (as shown at left), you do not have to
Hard drive
change this setting. If any devices are attached to the
CD-ROM drive
SCSI cable after the tape drive, you must disable SCSI
termination on the tape drive by removing the active
Tape drive
termination jumper (see figure at lower left). In either
case, the last SCSI device on the cable must have
termination enabled.
Check additional SCSI options
Check additional SCSI options
Check additional SCSI options
Check additional SCSI options
Check additional SCSI options
• SCSI termination power : The drive is shipped with
termination power enabled, which is appropriate for
most installations. If you have problems accessing
your tape drive, look in your SCSI controller manual
to determine if you should disable termination
power by removing the termination power jumper
(see figure at left).
• Parity checking : The drive is shipped with parity-
checking enabled, which will work in most systems.
If you have problems accessing your tape drive, look
termination
termina
termina
tion
tion
tion
termina
tion
17
Advertisement
