Connecting The Power Cord For The Wx1810H-Pwr Access Controller; Verifying The Installation; Starting The Device - H3C WX1800H Series Installation Manual

Connecting the power cord for the WX1810H-PWR access
controller
Make sure the device is reliably grounded.
1.
Connect one end of the AC power cord to the AC power receptacle on the device.
2.
Connect the other end of the AC power cord to the AC power source.
3.
Observe the LEDs on the device to verify that the power cord is connected correctly. For
4.
information about LEDs, see
Figure 16 Connecting the AC power cord for the WX1810H-PWR access controller

Verifying the installation

Verify the following items before you power on the device:
•
There is enough space around the device for heat dissipation.
•
The power source is as required by the device.
•
The grounding cable, console cable, power cord, and interface cables are connected correctly.
•
If part of the network cable for a port is routed outdoors, verify that a network port lightning
protector is used for the port.
•
If the power line is routed from outdoors, verify that a surge protected power strip is used for the
device.

Starting the device

Power on the device. The device initializes its memory and runs the BootWare image. The
1.
following information appears on the terminal screen:
...
BootWare Validating...
Press Ctrl+B to enter extended boot menu...
Press Ctrl + B at the prompt within 4 seconds to access the Boot menu. Otherwise, the system
2.
enters the system image file reading and self-compressing process.
To access the Boot menu after the system enters the system image file reading and
self-compressing process, restart the device.
Starting to get the main application file-- flash:/main.bin!...
"Appendix A Chassis views and technical
14
specifications."